This guide will show you the process of connecting your staff laptop to a Clevertouch interactive board, as well as additional information regarding the boards.
Connecting to Wireless Display
Step 1
Power on the Clevertouch board and press the following keys on your staff laptop: “Windows” + “K”
The “Cast” pop-up menu will then appear, select the board you want to display too.
Step 2
An invitation prompt will then appear on the Clevertouch board, press “Accept”.
Please note, this step will only occur the first-time you connect to board.
Step 3
A miracast request will then appear on the bottom right of the board, press “Accept”.
Once done, your staff laptop will start displaying to the Clevertouch board.
Step 4
Once connected, on the “Cast” popup menu, click the box highlighted in the image below. This will enable you to control your laptop from the board.
Freezing/Unlocking the board
Please note, these setting can only be toggled on/off using the Clevertouch remote. If this is missing, please contact the IT helpdesk.
Freeze the board – To freeze and unfreeze the screen, press and hold the Blue button on the remote.
(There is a short delay before the screen freezes).
Unlock the board – By default the board should be unlocked, however, if it is displaying a locked padlock icon, press and hold the Green button to unlock.
You must be logged in to post a comment.